IDing stuck injector

For Grand Banks, Alaskans, East Bay & Aleutian Yachts

IDing stuck injector

Postby Oliver » Tue Oct 08, 2019 10:40 am

Before backing off the pipes to each injector one by one, I was wondering if anyone had tried using an infrared thermometer to see which cylinder is noit firing. I am assuming that this should be done right after starting a cold engine so the heat of combustion doesn't heat up the entire block.
Oliver
Southern Lady
'71 GB 42 Woodie
View user's profile Send private message Send e-mail
Oliver
Posts: 412
Joined: Sun Jun 25, 2006 8:52 am
Location: New Bern, NC
Supporting Member

Re: IDing stuck injector

Postby rick s. » Tue Oct 08, 2019 8:42 pm

you might get a better result by using the ir thermo on the exhaust manifold rather than the block.
View user's profile Send private message Send e-mail
rick s.
Posts: 32
Joined: Thu Apr 22, 2010 2:51 pm
Location: Westminster, Colorado

Re: IDing stuck injector

Postby Oliver » Wed Oct 09, 2019 9:10 am

I think the water jacket might diffuse the temp and make it hard to be specific. Interestingly a lot of people have looked but no one has a suggestion. I guess SOP is just to remove them all and send out for pop off tests.
With modern fuel injection systems you can block one injector at a time. Guess I will bite the bullet and remove them all.
Oliver

Southern Lady

'71 GB 42 Woodie
View user's profile Send private message Send e-mail
Oliver
Posts: 412
Joined: Sun Jun 25, 2006 8:52 am
Location: New Bern, NC
Supporting Member

Re: IDing stuck injector

Postby gsholz » Wed Oct 09, 2019 11:05 am

To test, can't you just loosen the fuel line to the injector while running in idle? If there is no change in idle you found the bad injector (or bad cylinder).
View user's profile Send private message Send e-mail
User avatar
gsholz
Posts: 14
Joined: Thu Jun 22, 2017 11:29 pm
Location: PNW

Re: IDing stuck injector

Postby Oliver » Fri Oct 11, 2019 7:56 am

I am going to try that, thanks. FYI, Brian Smith told me to use mechanic's stethoscopes and listen to the fuel pipes where they enter the valve cover.
Oliver

Southern Lady

'71 GB 42 Woodie
View user's profile Send private message Send e-mail
Oliver
Posts: 412
Joined: Sun Jun 25, 2006 8:52 am
Location: New Bern, NC
Supporting Member


Who is online

Users browsing this forum: No registered users and 16 guests